get-imei: Get International Mobile Equipment ID get-imsi: Get International Mobile Subscriber ID set-pin2-protection : Set PIN2 protection state (disabled, enabled) set-pin1-protection : Set PIN1 protection state (disabled, enabled)
#Modem telkomsel flash menjadi 4g verification#
get-pin-status: Get PIN verification status get-capabilities: List device capabilities get-current-settings: Get current connection settings set-autoconnect : Set automatic connect/reconnect (disabled, enabled, paused) set-ip-family : Set ip-family (ipv4, ipv6, unspecified) get-data-status: Get current data access status autoconnect: Disable automatic connect/reconnect stop-network : Stop network connection (use with option below) autoconnect: Enable automatic connect/reconnect ip-family : Use ip-family for the connection (ipv4, ipv6, unspecified) auth-type pap|chap|both|none: Use network authentication type start-network: Start network connection (use with options below) get-client-id : Connect and get Client ID for service set-client-id ,: Set Client ID for service to mbim, -m NAME is an MBIM device with EXT_QMUX support release-client-id : Release Client ID after exiting keep-client-id : Keep Client ID for service device=NAME, -d NAME: Set device name to NAME (required) single, -s: Print output as a single line (for scripts)
![modem telkomsel flash menjadi 4g modem telkomsel flash menjadi 4g](https://cdn-2.tstatic.net/banjarmasin/foto/bank/images/ilustrasi-spg-telkomsel-saan-menggunakan-smartphone-4g.jpg)
Here is a brief help about uqmi command line usage. Timeout (in seconds) to wait for SIM operations Whether to use dhcp ( 1) or uqmi ( default) to get IPv6 interface configurationįirst three digits are the mcc (mobile country code) and the last three digits are the mnc (mobile network code), for example if plmn=338020, then the mcc is 338 and the mnc is 020 Whether to use dhcp ( default) or uqmi ( 0) to get IPv4 interface configuration Used IP-stack mode, IP (for IPv4), IPV6 (for IPv6) or IPV4V6 (for dual-stack) Seconds to wait before trying to interact with the modem (some ZTE modems require up to 30 s.)Īllowed network modes, comma separated list of: all, lte, umts, gsm, cdma, td-scdma
![modem telkomsel flash menjadi 4g modem telkomsel flash menjadi 4g](https://i0.wp.com/cekandroid.com/wp-content/uploads/2019/12/modem-telkomsel-flash-4g.jpg)
See Troubleshooting Section of this page for more information.Īuthentication type: pap, chap, both, none Or look info about USB devices and interfaces present in the system: Try dmesg to read kernel logs on USB init If you have no such device - try to find out what went wrong: Check that everything is OK and You got new device:Ĭrw-r-r- 1 root root 180, 176 Oct 1 12:03 /dev/cdc-wdm0 Refer to your router Forum thread for possibility and instructions.ģ. If your have not enough space on your device - think of installing Rootfs on External Storage (extroot)Īnother option is Hardware memory upgrade.
#Modem telkomsel flash menjadi 4g install#
Opkg install usb-modeswitch kmod-mii kmod-usb-net kmod-usb-wdm kmod-usb-net-qmi-wwan uqmi